🚧 ICBEAMER 6-Function Waterproof Reverse Tailgate Review

I would have liked a little more adhesive so the ends don't want to stick as well. You need to decompose it in a warm room for 24 hours. The ends wanted to keep curling up. I wiped the surface with alcohol three times before installation to clean the surface. That brightness aside, I'd try to give it an 8 out of 10 based on my installed reverse and brake lights. I was hoping for something lighter. Overall I would buy again. Add glue around the edges. Installed on a hot afternoon to get the glue

Received and fitted this light strip today. Installation is very easy, from tailgate removal to wiring, it took about 15 minutes. I only hardwired the taillights and reverse lights, I have the 4 pin and 7 pin trailer connectors side by side so I only used the 4 pin connector that came with the kit but I will connect it later. It's another 15 minutes if I do it. All lamps work and do what they should. I don't know the durability and as long as they last a year or two I don't care because for $18

Duct tape didn't stick at all I had to use zip ties after drilling a few holes in my truck and a few drops of Gorilla Glue to keep it in place. Only half of the light bar is illuminated by the daytime running lights. The reversing light is surprisingly bright at night and helps when reversing in the dark. Buyers beware, you get what you pay for. Consider spending another $20 on another LED strip and you will most likely end up with a superior product. I work very hard to pay for my truck and I…

A light bar was connected and the chase function stopped working after an hour. I made sure the voltage was applied correctly and then sent the Revain strip back for replacement. After installing the replacement strip, the chase function didn't work at all, but I chose to use it as is. After about 2 weeks, the right position light function worked, but the right turn signal function stopped working. When the truck's right-hand hazard lights came on, the left side of the lightbar glowed dimly…

I expected it to be brighter than it is judging by other reviews. In general I'm happy. As they say, it fits my truck, but it doesn't. My fault for not measuring very well. It can be cut, which is what I did. Filled the cut end with black RTV to seal it. What I didn't think of is that when cutting, the center line between the right and left turn signals now shifts towards the cut end. The left signal reaches the right side of the license plate. The right signal is much shorter. Two things you…

Looks great. For €18 it doesn't get any better. Installation took a little while as I wanted it right. Cut the pigtail and connect directly to the wire harness that feeds the trailer's electrical connector. I used waterproof shrink butt connectors for all lights except the reverse lights. The reversing lights were spliced directly to the taillight. Overall I'm very happy with them and they look great. Fastening material is crap. just throw it away Rely on 3M tape. I added a strip of 5 minute…