🔌 5202 to H11 Pigtail Socket Wire Conversion Kit for Subaru BRZ & Scion FR-S Fog Lamps Retrofit Review

Works great at many times cheaper than alternatives of equal function and component quality. Applying dielectric grease to both connectors and a silicone or RVT gasket on the back of the H11 end will make them bulletproof.

good product but if you want to use leds you need to reverse the polarity. The kit I received came with the polarity reversed. You may just need a little or something, pull out the pins and flip them over. in the base.

was used for 5202 fog lights on a 2012 Silverado. The center locking pin is a little oversized and prevents the factory strap from locking when fully depressed. I took an x-acto knife and shortened the tongue a bit and it worked great.

Works as advertised. Was able to use them to hook up aftermarket fog lights to my car. For me, the piece of plastic that connects the pins of the stock wiring harness didn't quite work. So I just taped the connection and then taped it. Excellent value for money and quality

This kit came right out of the box and works on my base 2015 Subaru Impreza. This allowed me to use H11 fog light bulbs with stock wiring harness. After 2 months of use, no problems with water or corrosion. They only connect to the standard wiring harness one way, so make sure the tabs match.

Works as it should, the spark plugs fit perfectly with both the car and the new headlight. Tie the excess wire and connectors further into the bumper (remember to leave enough slack to easily change the bulb) and you should be good to go.

Honestly. I buy an adapter to have everything in stock on a vehicle that has yet to be paid for. Except that the adapter has a random keyway tab that doesn't allow it to sit which I couldn't cut off. In the end I just bumped the end I needed. It was the cheaper item I could have bought first. (Yes, I checked vehicle compatibility before purchasing. Twice.)

I installed fog lights on my 2014 Impreza for less than $90. Subaru does all the wiring so you don't have to rewrite. The relay is located behind the lower right slot of the glove box in the relay box. Added OEM switches (you just cut blanks on the panel) and aftermarket fog lights (just remove bezels), attach this subaru connector to h11 adapter cable. You can get Subaru headlights for a lot more and skip the adapter cable.