Autmotive Authority White Vinyl 1-inch Insert Molding Trim Screw Cover for RV, Camper, and Travel Trailer - 100 feet (White) Review

I bought this to replace most of the original fairing on my 26ft motorhome. Something was missing, something was torn, something was just ugly because of tape or caulk. It goes over a rut easily, but be very careful to buy the right width - it comes in several sizes and too wide or too narrow doesn't work well. I think I probably should have bought the 7/8" wide, but the 1" wide works. Makes the camper so much better.

I bought 100ft black. It fit perfectly in both my slide and the roof seam where the existing one ripped and blew in the wind as I rode. It was easy to work with and fitted easily into the seam. The product measurements were helpful in making sure I received the correct item. It's a little thinner than the one originally on the camper so time will tell how well it holds up. The original casting lasted 3 years.

I worked at a dealership and put many miles on this trim. This casting is extremely rigid and takes a long time to install. Spend the extra money and get a Camco that's a lot smoother and easier to work with and you'll be way ahead of the curve in terms of work! I had to wear gloves to avoid injuring my fingers. His arm hurts from trying to squeeze him in the tracks. Anyone who has left good reviews has apparently never used a good product.

Revised Rating: In just a few months replaced parts have shrunk about 1 inch on an 8 foot strip. This means the end is now "open" and I had to cover it with silicone to keep the rain out - and that would make a mess the next time you change! OEM vinyl trim on my 2019 Rockwood MiniLite just over 1 year later! Make sure you set this up on a nice warm day otherwise setup will be a lot more difficult. Hopefully this replacement material will last longer than OEM junk.