JFG RACING Universal Removable Motorcycle Review

Works great on my Ninja 650! Very simple setup, damn loud and looks pretty cool. I've had two brothers' exhausts before, but this one is just as good and a lot cheaper. I highly recommend it.

evidence in the video. If you want your bike to produce a nice guttural sound, this is the tube for you. I installed a 171cc scooter, NOT a motorcycle, but now it sounds like you're telling me.

Deflector bent (inside the exhaust and outside) I'm pretty sure I got a used or the returned one as the parts are damaged and worn. One of the springs didn't have a second hook. I expected better.

Quality rubbish. I bought it twice and twice it broke while cycling. It is dangerous and should be banned from sale. The rear end flew down the street and the noise was very loud. Don't waste money. Customer service is so difficult that Amazon had to help.

later Sounds great. Less than expected. And it will most likely need an extra piece or elbow to make it work. I did not fund a way to contact the seller. now I can't ride a motorbike, it's very noisy. And they will stop me. Without this incident I would be a happy customer. If you buy this product, be sure to attach the dreadlocks to all the screws before you test ride.

I welded the muffler to a separate pipe and used the clip that came with the original muffler to install the muffler. I also made a bracket out of aluminum but in time I may replace it with stainless steel. Especially on my bike it sounds very good at low revs, but on the highway at high revs (7k+) it sounds very much like the engines of a small airplane flying overhead. Very high-pitched tone and metallic/tinny sound. It's louder, almost as loud as without the exhaust. The black color rubs off

I was looking for something to turn down the volume on my Honda Rancher 350. It came with a "db killer" that caught my attention. It only took a few minutes to install, I fired it up and to my surprise it actually reduced the volume significantly to the point where you could speak normally at a controlled volume! Then I decided to remove the db killer, god that was a drastic change! It went from quiet to so deep and hoarse that everything nearby vibrated, and that was only at idle. With the DB…

The video quality is terrible. This exhaust was perfect for my Briggs & Stratton V-Twin lawn mower. The kids love mowing the lawn as it sounds like they are riding a motorbike. I didn't remove the baffles as I don't think it's necessary as the motor sounds great! Even my neighbors say it's not that loud and sounds good. I didn't use springs for the sliding adapter. I actually welded it to a 2" stainless steel bend at a 90 degree angle. I used my HarborFrieght 90-Amp cored wire welder and was…