Header banner
Revain logoHome Page
πŸ”§ jonard ft6 flaring insertion length tool logo

πŸ”§ Jonard FT6 Flaring Insertion Length Tool Review

3

Β·

Poor

Revainrating 2 out of 5Β Β 
RatingΒ 
2.0
πŸ”§ Industrial Power Tools, πŸ› οΈ Industrial Power & Hand Tools

View on AmazonView on Π―M

Media

(2)
img 1 attached to πŸ”§ Jonard FT6 Flaring Insertion Length Tool
img 2 attached to πŸ”§ Jonard FT6 Flaring Insertion Length Tool

Description of πŸ”§ Jonard FT6 Flaring Insertion Length Tool

The flaring end of the tool facilitates the expansion of the cable providing easier insertion of "F" connectors. The insertion end makes "F" connector insertion fast and easy, even in cold weather. This tool is recommended for use on polyethylene jacketed cables and plenum cables, and is especially helpful when using tri-shield and quad-shield cables. 4-1/4-inch length.

Reviews

Global ratings 3
  • 5
    0
  • 4
    0
  • 3
    1
  • 2
    1
  • 1
    1

Type of review

Revainrating 3 out of 5

WILL NOT WORK with RG6 Quad

Sturdy little tool but it just WILL NOT work with the RG6 Quad (Southwire) coax I bought from Revain. The end of the flare tool will not fit the dielectric/foil and will damage both if twisted a little. The end of the insertion tool is great for inserting the prepared end into the F connector.

Pros
  • Parts and Accessories
Cons
  • Available in white only

Revainrating 2 out of 5

Great tool but doesn't help in all situations

It could be a combination of wire and connectors but I found that in most cases it flared (even after reading the unplugging instructions had followed). spine shield) did not help. not enough to help. In cases where this worked well, you didn't even need to flare that combo or cord and plug. The part where you screw the connector on and get some leverage was a nice feature though.

Pros
  • Soldering and Soldering Supplies
Cons
  • So far so good