🔍 Improved Searchability: Jones Exhаust JTD112 Review

Very high quality chrome! Used to redirect the exhaust to the John Deere 1025R. I had to cut slits at the end to tighten the clamp.

This exhaust tip was purchased to replace a lighter material that was lost due to vibration. This assembly is meant to be welded, but I sawed about 1" in the back with a hacksaw and installed it with a regular muffler clamp. Works great and is much stronger than the ones I replaced.

This exhaust extension was just what I needed for the short tailpipe extension on my Ford NAA tractor. A little unusual due to the chrome finish, but it adds a little class to the old tractor. It fits nicely into an existing 1.5" exhaust pipe. I clamped it with an exhaust clamp after cutting a few slits in the end of the extension so the clamp could be more secure. I used a 1.75" ID exhaust clip because the 1.5" ID clip I had was too small. The 1.75" was a little large but works well and the…