Joyway Inflator Valve Connector Stainless Review

Easy replacement for a broken air liner on a portable compressor. Seems to work better than the original manufacturer's solution.

The tire inflation valve is easy to fit. This is a quality product that should serve me for years. I replaced an inflation valve that failed after 20 years of use. I checked the inflation and the accuracy was correct.

The description says 1/4 inch. The 1 I received looks like it was made for a 1/8" vacuum line. Sending it back. Be sure to read the description before buying. Did a little more research and found the 1 I need. I think.

This air sleeve attaches securely to the air restrictor on my Trek bike's rear shock and releases quickly enough to prevent the pressure from dropping after inflation. The air pump I bought came with a cartridge that was too big and bulky for the job and it solved both problems at once. I used this to modify the extension hose instead of cutting the two valve heads off the pump hose as this head would also bleed my presta valves.

Works like a charm. The old fitting on my Black and Decker has survived. You can put a valve on a car tire, but on bike tires the fitting is simply deflated before the tires reach full pressure. So I was looking for a new compressor and wasn't thrilled with the choice. I saw this fitting and was hoping it would fit given the 1/4" inner diameter. I cut off the old fitting and put this on, it fit perfectly and filled the Pronto tires. I saved $75 doing this

I have a 2hp compressor with an integrated hose that is marked '1/4 ID'. The 1/4" was too small and the 5/16" was also too small, but I was able to pull the live 1# out of the yoke and get a seal. " is slightly larger than the ID and the notches in between are the same as the ID. This is a quality product and customer service is timely. Look for a size larger than this 5/16" if your hose ID 1/ is 4" for a snug fit.

I needed to replace the valve on my trusty and very old tire compressor. After looking around a bit, I settled on this one. They look high quality and are easy to install on a 1/4" compressor hose. The valve fits 'well' to the hose and the clamps are the right size. Generally the installation was quick with no problems. Only suggestion The one I have is to make sure you position the pinch screw down or away from the valve lever.The valve itself worked perfectly on my car's tire stem with no…