LED waterproof strip RGBW 5050 LED with remote control, 5 meters (54L s/m) Review

Pros below: It shines well, it works too (an important point, you need to connect the arrows on the connection details when connecting the tape to the controller) Everything is written in detail in the instructions. Different cons: The protective layer is not the most durable, it breaks easily due to which moisture can get on the tape itself. For installation on the street, in aquariums, in the bathroom, and so on, it is not suitable, you need to take it with a higher water protection class. Th

When buying, I advise you to immediately throw out your own power supply! and put some other but not less than 1 ampere! since this one I’m even afraid to say, apparently it’s designed for only 2-3 LEDs)) I first installed the tape, it seemed to work . but two days later (I have a segment under the table of 110 cm) Only 110cm!)) while working, it literally took an hour! I decided to play it safe and touch how it is there ?! put his hand and she is very hot! (I can imagine what will happen if…

I completely unfolded the tape, two LEDs were already melted, I wanted to make a return at this stage. But I decided to check anyway. For the first half a minute, everything worked, the melted LEDs worked, but they stood out strongly against the general background. After two or three switches on the remote control, the white light stopped turning on, yellow was on instead. And in the end, after a minute, the power supply cracked, I immediately decided to turn off the power, I didn’t have time…