🔥 Lynn Manufacturing High Temperature Gasket Paper 1/8" Thick x 15" x 24", 4 pcs/pkg, 2100F Rated for Wood Stove, Pellet Stove, Boiler, Furnaces, Kiln, Forge, 9600 Review

It's good to have an old stove on hand that I can't find gaskets for, sometimes I find a gasket and it's 10 times more expensive than it should be, so i will have to make one. The material is quite difficult to cut, but it can be done by hand with a very sharp razor and some patience.

Over time and hot fires, the asbestos material that insulates the glass front of my wood stove has deteriorated, causing the glass panels to come loose and smoke to escape. I cut the release paper and attached it with high temperature sealer. That works great! It's nice to have warmth in my shop again.

I bought this to make a new gasket between the fan motor and fan assembly on my 12 year old pool heater (Pentair MiniMax NT LoNox). The seal had worn out and was creating a low vacuum at the vacuum switch, causing the heater to shut off unexpectedly. After cutting out the gasket with scissors and reconnecting the fan motor everything worked great.

This is an easy to use gasket that can be cut with scissors. I have used this spacer on two different Empire 30,000 BTU ovens. These Imperial stoves have room to relight the igniter or simply check that the heat couple has a flame. If you check to see if there is a flame, the old gasket will just fall apart. Here I used this new high temperature gasket. Easy to install and works very well. I would buy it again if I needed more.

We have a convection wood stove (Longwood MK VII Dual Fuel) where the ash door needed a new gasket change - this is the version with the gasket cable It doesn't seal well and looks not at all like the original gasket. The original gasket was white, thin, flexible and worked great. but it was asbestos. It was great to find this deal and these sheets are similar in every way that matters - they seal the entire door, not just the edges. Easy to cut with a utility knife, the size we need is only…