🌟 Pack of 10 Meerkatt 3/4 Inch Mini Round Amber LED Bullet Side Marker Clearance Lamp with Rubber Grommets - Waterproof Marine RV Bus Trailer Truck ATV Indicators, Signal Lights, 12V DC Extra Brightness Review

Was pleased with the product and the ability to pivot the light where I wanted it. The lamp provides a horizontal or vertical direction, not an even distribution. It's good for what I wanted.

Used these on my snowmobile trailer and they look great, easy to install, drill a hole and put in place. Update, it's January 2021 and one of the yellow ones is already out of service. I only use the pendant a dozen times a year or less so I'm a bit surprised it hasn't held up better.

I used them in a headache rack. The backlight is solid like most 3/4 inch markers, good brightness and good sealing. My only complaint is that it only worked 9/10. I spent more time troubleshooting my wiring than I should have just to find a dead LED. Test before wiring.

This is a well made lamp. It's everything you would expect and great value for money. I like the fact that the light easily slides out of the rubber case (don't get me wrong, it doesn't fall out when it's on). This means it's easy to replace or change to a different color.

Very easy to install. Drill a 3/4 inch hole, insert a decorative sleeve, and then insert the lantern into the sleeve. I was able to pre-assemble my entire kit, thread the line into the wall, fish out each of the holes, and then place and reinsert the insert bushings. I also like how tight they are. My rig is in a pretty harsh environment and so far they're working great.

Bought these to use as reversing lights for my new integrated parking lights. Didn't think they would work well for the price. After installing one on each side I was very impressed with how bright these little lights were. Great purchase and I have 8 left that could probably be used as stone lights in my jeep's wheel wells/belly. Definitely recommended for the price.

Be sure to check the polarity of the cables. I mean, it goes without saying. The old lanterns were PITA for going out. Just make sure you have some sort of hook to pull out the old wires. When installing these lights; Without the rubber grommet on the headlight, they are a little easier to insert. Once the old lights go out; connect wires; remove the bushing; Install the light in the grommet.

Excellent product - I liked it. I have previously submitted a review where I was concerned that the lighting was not working. After writing the review I did a little research and found that the color code is different than what you would expect when hooking up this item. Black Lead would have been Ground or (-), but it wasn't. And White's move would be positive (+), but it isn't. They have been turned. I'm not sure why, but as soon as I read this, other users with similar problems reported that