🔧 Exploring the Power of Precision: Metric Drill Bit Set Pc Review

So far they seem to be working fine. Not sure how long they will last. My only complaint is that they are too long to capture in quick release as they should be. I don't care about the price, I don't plan on using them widely. I can use them in a quick release but be aware they will fall out or bang into a drill. I can try grinding them shorter. Then maybe I can use one to deburr the other 😉

I read the reviews about it and liked the products but wasn't sure what I was getting. Well a project came up and I needed to use them. I put it in the drill and gave it a light squeeze and it did a great job. I deburred 1/4 of the screws that go all the way down, so this really is the smallest size. But he did exactly what he promised. I only made 8 grade 5 bolts so I don't know if they cut grade 8 steel or stainless steel or how many times you can use them. But for that kind of cost, if they…

Can't give 5 stars because the shaft won't snap into my Milwaukee or Makita hex drivers. Essentially, the hex shaft is not long enough to allow for activation of the ball bearing retainer and this occurs at the point where the hex shaft expands into a cone. My hex collets hit the taper before the hex shaft is fully seated. This allows the debut bit to fall out of the hex driver if left hanging. Essentially, the hex shaft needs to be 1/8 inch longer before the taper begins.