Monoprice Workstream Dual Arm Adjustable Gas Spring Desk Mount - Silver, 15-34 Inch Monitors, Vessa 100x100, 19.8lbs Weight Capacity Review

Fits 24" and 34" wide screens. The full movement of the arms makes it easy to hold the screens side-by-side, pivot the smaller one vertically if needed to view documents, or slide it completely out of the way to use the larger one as a single monitor. The only downside is that my 34" display acts as a dock/KVM, so the number of cables going to the monitor far outweighs the built-in cable management channels on the brackets. The hand has no problem maintaining vertical or horizontal position, it

Excellent product. I bought 2 LG 34" wide monitors and didn't want to put them on my desk. My monitors came with their own desktop mounts but I didn't need them. It has two installation options. 1) Clamp to attach to the back of the desk or bolt for desks with hole.I used a clamp it's strong and works very well.I put my desk with the monitors in place and it didn't move at all.This dual monitor mount is exactly what I was looking for have, and it works great and allows me to repurpose my entire

Good product at a competitive price but there are defects. One of the arm screws holding the monitor's attachment point broke off after only light tightening. The stand I replaced it with for the 24 inch monitor had a stud about twice the size. Some stock high-strength Triumph Speed Triple bolts now hold the 34″ LG. I have a feeling that the size of the main bolt used to secure the stand when you drill a hole in the table is too small and doesn't hold the stand properly. The box says it only…

Great monitor arms, easy to install, easy to use - don't worry about the incredibly low price; it's quality! I was concerned when the box arrived and I noticed that it listed monitors from 13 to 32 inches, not 34 as advertised. I photographed the box in case there was a catastrophic failure and my huge 34 inch monitor was damaged. It turned out that my worries were unfounded. Promised. I wear the 34" Ultra Wide on my left hand and the 27" Wide on my right hand and they match very well. I'd be…

I have had several Monoprice TV stands before but this is my first monitor stand. It is very well made and was quite easy to assemble. I have a table with backs and no ledges so I decided to drill a hole. The M8x1.25 screw fits the 5/16 inch hole snugly and tightly. However, since I wanted to place it as close to the back edge of the table as possible, I couldn't use a large hand-tight nut - there wasn't enough clearance (see picture). A quick trip to the hardware store for an appropriately…

So will this monitor fit a 17lb 34" monitor? Technically. Yes. But it didn't come without crazy torque, extra tools and compromises. This monitor might not have the best tilt feature, but it looks pretty good acceptable torque for tightening the tension washers it is possible to get this stand to work but actually it doesn't and it's a headache I couldn't get this stand to work due to the bolt system with the Tightening system is designed the way it is.It is impossible to tighten the screw…