Optimized Mounting Bracket with Protective Frame & Lens Cap Housing for Insta360 ONE X2 Accessories Review

Easy to install and use, all cutouts are pretty damn good, LEDs are fully visible, buttons work, screen, lens in the right place and even the 1/4" screw hole lines up. What I like best is the lens cover, I can put it on and not have to worry about putting the camera on a hard surface.

A thin black line appears in all my photos that no lens adjustment can correct. The lens cap only fits when the body is on, so I can't use any of the parts. Even if I put up with a ruler, case and cap, if I hold it upside down and shake it a bit the cap falls off - it's a loose fit.

Easy to install and use, all cutouts are pretty damn good, LEDs are fully visible, buttons work, screen, lens in the right place and even the 1/4" screw hole lines up. Lens cap the most, I can put it on and not have to worry about putting the camera on a hard surface.

All my photos have a thin black line that no lens adjustment can fix. The lens cap only fits when the body is on, so I can't use any of the parts. Even if I put up with a ruler, case and cap, if I hold it upside down and shake it a bit the cap falls off - it's a loose fit.

So snaps in well but the housing makes it difficult to unplug the USB-C connector. Also, the plastic body makes it a little flexible, so if you mount it on a motorcycle like I did, the whole chamber vibrates from side to side all the time. the amount of pressure to force the bolt to engage the first thread of the nut. The small wrench was handy for tightening, it keeps the body snug and tight. If you only use it to attach to a selfie stick or maybe a suction cup mount that can absorb some…

I like the matte thin film silicone coating over the plastic which provides extra drop protection. The main purpose of this accessory is to provide you with a professional bottom mounting experience as this camera only has a 1/4 female bottom thread to begin with. So now you can use your one x2 with Go Pro attachments. Comes with a 1/4 female and a GoPro connector if you want to use that instead of the native 1/4 connector on the camera as you now have access to the tilt but remember you can…