Header banner
Revain logoHome Page
πŸ›₯️ owach al 958 2: quality southco marine replacement for optimal performance logo

πŸ›₯️ OWACH AL 958 2: Quality Southco Marine Replacement for Optimal Performance Review

3

Β·

Very good

Revainrating 4.5 out of 5Β Β 
RatingΒ 
4.3
πŸ”’ Latches, πŸ”© Industrial Hardware

View on AmazonView on Π―M

Media

(2)
img 1 attached to πŸ›₯️ OWACH AL 958 2: Quality Southco Marine Replacement for Optimal Performance
img 2 attached to πŸ›₯️ OWACH AL 958 2: Quality Southco Marine Replacement for Optimal Performance

Description of πŸ›₯️ OWACH AL 958 2: Quality Southco Marine Replacement for Optimal Performance

2" round-hole installation. 0.475"-0.675" door thickness (12mm-17mm). Stainless steel screws and keeper. The flush profile and easy installation makes this latch perfect for hatches, livewells, electrical enclosures, and other compartments on your boat.

Reviews

Global ratings 3
  • 5
    1
  • 4
    2
  • 3
    0
  • 2
    0
  • 1
    0

Type of review

Revainrating 5 out of 5

Perfect replacement for Stow & Go latch

This product saved me $40 replacing a Stow & Go latch on my 2018 Chrysler Pacifica. The replacement costs $50 direct from the Mopar website. Works better than the original factory part. Can be opened easily. Absolutely to suggest. Thanks very much!

Pros
  • 2" round hole setup
Cons
  • Can't remember but something was

Revainrating 4 out of 5

Cheap but not ideal replacement.

Purchased to replace a broken Stow 'N' Go latch on a 2018 Chrysler Pacifica. The part that latches doesn't reach the OEM latch so sometimes it won't latch or latch into the floor but still sits flat without rattling. Reuse the backplate of the OEM latch as the one supplied has small ribs on the back that prevent it from sitting flush when you screw it in.

Pros
  • Stainless steel screws and holder.
Cons
  • Will be added later

Revainrating 4 out of 5

Purchased for Chrysler Pacifica

Purchased for 2018 Chrysler Pacifica. I ordered a Stow n Go clasp as a replacement. The latch mechanism was too deep to latch, but I was able to knock out the roll pin holding the latch handle itself and then install it into the original latch. It was a good decision and saved a lot of money. I ordered a 1/2" latch so maybe 1/4" will do if that means the latch depth. Otherwise just steal the handle, it fits the normal mechanism.

Pros
  • .475"-.675" Door Thickness (12-17mm)
Cons
  • Requires Socket