Header banner
Revain logoHome Page
πŸ”‹ enhance power transmission with pgn 6203 2rs sealed ball bearing logo

πŸ”‹ Enhance Power Transmission with PGN 6203 2RS Sealed Ball Bearing Review

3

Β·

Poor

Revainrating 2.5 out of 5Β Β 
RatingΒ 
2.3
πŸ”© Bearings, πŸ”© Power Transmission Products

View on AmazonView on Π―M

Media

(3)
img 1 attached to πŸ”‹ Enhance Power Transmission with PGN 6203 2RS Sealed Ball Bearing
img 2 attached to πŸ”‹ Enhance Power Transmission with PGN 6203 2RS Sealed Ball Bearing
img 3 attached to πŸ”‹ Enhance Power Transmission with PGN 6203 2RS Sealed Ball Bearing

Description of πŸ”‹ Enhance Power Transmission with PGN 6203 2RS Sealed Ball Bearing

Dimensions: 17x40x12 mm. Rubber seal on both sides. 100% Chrome Steel for higher resistance and durability. Supports 20,000 rpm. Our high-quality bearing is made to reduce your replacement frequency and maintenance cost

Reviews

Global ratings 3
  • 5
    0
  • 4
    1
  • 3
    0
  • 2
    1
  • 1
    1

Type of review

Revainrating 2 out of 5

I would ? Quality of drivetrain products

Correct fit but clearly not of high quality had to replace it after a month on a 2hp pool pump. caused the problem in the first place) I bought a set two years later thinking I had bearings ready to be replaced again in the future, but as they failed after a month I don't think I'd bother with a second one sentence would make.

Pros
  • Supports 20,000rpm
Cons
  • Not as thick as other picks

Revainrating 1 out of 5

Looked ok out of the box, broke down in less than 50 miles. twice.

The first bearing was installed with a hammer seat. Was silent for about 50 miles then started screaming on takeoff and was very loud until warmed up. Maybe I messed up installing it? So I replaced it with another one from the package using a hydraulic press (the correct way to install) and again it was fine for about 50 miles and then started screaming again at start until it warmed up. I do not recommend this camp.

Pros
  • Dimensions: 17x40x12 mm
Cons
  • Drill package

Revainrating 4 out of 5

definitely a good short-term solution. Not sure how they will hold up

They are so cheap I'm a bit cynical about quality but hey - my fault that I was influenced by the price! although they might prove to be excellent bearings - will try to report back in a while - have seen some complaints that they aren't filled with enough (or any) grease but I'm not sure that's true - they are only lubricated on one side - grease penetrates quickly through the rest of the bearing

Pros
  • Our high quality bearings are manufactured to reduce replacement frequency and maintenance costs
Cons
  • Easily crumpled