🖼️ 10-Pack Adhesive Picture Hangers - Plastic Sawtooth Hooks for Easy Hanging - Ideal for Foamboard Review

Easy to attach while you work. I have used the product to hang decorative tiles and it works. Note - do what is written in the instructions. Allow the product to "cure" for 24 hours before displaying and ensure the item's weight is light. This will not work on heavy platters or plates.

These picture hangers do exactly what they are advertised to do and are of a much higher quality and 'stickiness' than the old paper hangers. It has a hard plastic backing/hanger with a very lightly padded area of self-adhesive material. Simply peel, apply and your item is ready to hang. For light items, this product is perfect.

The idea is simple, stick on the frame and hang it up. Of course, remember that your frame is not too heavy or comes loose. And he definitely switched off. However, what has been removed is the adhesive on the plastic bracket, not the adhesive on the frame. how can this happen? Shouldn't you make sure that these parts are inseparably connected at the factory? In the picture, the top one is unused and the bottom two are "after use".

This product was useless I followed the simple instructions Put up a small canvas print that weighed no more than a pound! Two separate attempts, with 2 separate products One of the canvases was damaged in a fall wall3m's products are superb, to be honest there is something very strange here! I bought an unbranded Chinese product and it worked great! Seller should check this as these are obviously faulty, USELESS PRODUCTS!

I had these old hangers a few years ago and they worked great. They are useless and dangerous to use if you care about what you hang. I used them to hang posters on foam board and the several ounce weight of the poster ripped them. At first I thought it might be a defective hook. But now it happened 8 out of 10. When the posters fell, at least one corner was crushed, ruining the poster. I hope they can be reinstalled but I'm not sure if they can be removed from the foam board to install on…

I shoot a lot, both ground and astrophotography. I have dozens of unframed prints in gator, aluminum, and acrylic that I hang around my home and office and change up from time to time. I don't frame often, so I needed a reliable way to hang those unframed photos on the wall. Some of my prints are the same size and are 20x40 and 16x48 - not heavy, but not negligible either. I tried these sticks on hangers and I really liked them. In the years since I've used them, none of them have shown any…

20x30 photo spray glued to styrofoam for photo montage. One problem with this is that the foam warps because one side absorbs more moisture than the other. The styrofoam inevitably warped to the point where the commando's adhesive fumes dispersed and the styrofoam fell off the wall. on both sides of the plate to avoid deformation. I bought 3M Command 17047-ES Picture Hangers and these sticky plastic sawtooth hangers. I attached a Command picture hanger to the wall and a sticky sawtooth hanger…

According to the product description they can support up to 3 lbs. I attached them to frames that weighed just over a pound each. Within two days of hanging, several frames fell off the wall, one of them in the middle of the night. I suspect this is because I live on a busy road and the transmission of the vibrations may have made it less stable than another part of the house. However, this is not mentioned anywhere in the description as a warning or feature. And those frames were well under…