💡 Pack of 10 Male + 10 Female CENTROPOWER 5.5mm x 2.1mm 12V DC Power Connector Jack Adapter for Led Strip, CCTV Security Camera, Cable Wire Ends Plug Barrel Adapter Review

Required to install a security camera. They were a lot easier to use instead of crimping the wires. Will buy more if I need them again.

Wires can easily be pulled out of terminals so add some solder if you like or just make sure there is no voltage when connecting your projects. I need 10 packs for women only! There are already many existing adapters.

I use them to connect my train lights and transformer. Since my layout is Christmas, wearable; I needed something that would connect/reconnect easily and connect easily - and it's perfect. In the bag is enough for my other layouts or other projects.

Anyway, a lot of my devices run on 12V and when I use them in the RV I can plug them directly into a DC power source rather than wasting the overhead DC-AC Inverter. just to get back to DC. I bought two sizes to make sure I got the right size. Worked great, fits well.

I'm always afraid to screw and unscrew wires in these little clips. Boring. No longer. With these connectors I only have to do this once and my projects become much more modular (I can swap out components with plug and play. I will be getting more of these.

This is probably the third batch of these handy little connectors I've bought for the store. Threaded wire connectors are strong and durable, accept a variety of wire gauges, and have clear polarity markings. None of them failed or broke. Affordable, strong and useful.

I used these when upgrading my 20 year old camera. The new cameras worked "plug and play". When the house was built I had a low voltage camera wire run through the roof system. I added one of these to the end of the camera. Then another at the power end. Both connections fit perfectly. The best part is that I didn't have to run a new cable.

These connectors work well with one exception. Maybe it's my fault, but the screws on the terminals didn't hold the wire well when tightened. I had to tighten the screw and/or strip and reinsert the wire several times before I got a good, solid connection. It could just be the wire I used or something else. Anyway, that was my experience.