🔩 Brainwavz Screwless Wall Mount for Eero Mesh WiFi | VHB Stick On Holder, Easy Installation, Strong Adhesive, No Drilling | White Review

I wanted to use this mount without the adhesive pad that came with it. The included pillow would be nice if you never had to remove the mount. I wanted to use the 3M command bar. I had to remove the included adhesive pad which was very difficult. The rest of the mount works as described. This was the only one I could find that was designed for bottom cable entry.

Ero is mounted outside on a brick wall. Instead of using glue I went ahead and used a plastic dowel with a screw. It would be helpful to only have this option instead of drilling a hole in the middle of the glue. I suspect the adhesive will bond well to the brick, but I also prefer to err on the side of caution and hot/cold cycles can cause adhesives to behave abnormally over time. It would be nice to have a 2 pack for around $5. more. Pretty expensive ($15) for a mount.

I really like the holder. The material is strange, but it's not cheap plastic at all. I'm not sure if it's plastic. I didn't trust the glue to place it where I wanted it so I made a hole in the center and installed it as I couldn't find a hole mount. I used a large screw to make a hole and there was still room for the mesh to be inserted. The mount is very tight and definitely won't fall off.

This is perfect for my Eero but it's obviously 3D printed which wasn't mentioned in the description. This means there are lines and burrs in the 3D printing process and it doesn't look smooth or "finished" at all. Also, it's far from being white as advertised on the Eero - it has a yellowish tinge and is a much more "bone-colored" or "off-white" color. So it gets 2 stars just because it fits well.

These mounts are good. I didn't know they were 3D printed until I got mine. At first I was concerned that it was 3D printed, but once I got my hands on it I found it durable and quite thick. It was easy to assemble and install on my Eero. It worked so well I got a second one for the extra Ero I need to install for a clean look.

A little tight but nice. I had to move mine and found the adhesive wouldn't peel off your wall without damaging it. I like that this adhesive strip is fantastic. It's bad if you plan on moving this thing around a lot. Although I really like the design and you can drill a few holes in it if you prefer to attach it with a screw or two. I think it's sturdier than the pedestal mounts you see on Revain; However, it depends on what you need for your application to determine which is best.