🔮 Translucent Silicone Mold Making Kit - Easy 1:1 Mixing Ratio for DIY Resin Molds, Casting, Jewelry Making, Manual Making, Crafts - 22 oz. Liquid Silicone Rubber Review

I've tried using this silicone several times. Never fully healed. Even after it's cured for over 48 hours it's still fluid and fluid when in contact with the items I'm trying to cast. I literally wish I had never bought this and wasted my money

This material is very easy to work with and would be a fantastic silicone to make molds if it weren't for a small detail. it doesn't harden properly. The outside of the mold is solid but some liquid residue will remain. Inside, even after 3 days of curing, the mold is filled with uncured liquid residue, rendering the mold virtually unusable. 8 minutes and was completely degassed in a vacuum chamber before filling. As previously mentioned it was left to cure for several days instead of the…

Let's go deeper. I have a small shop where I sell silicone molds and other stuff. I've been working with "let's resin" transparent two-component silicone (distributed by let's polymer, no decorative space, it has a different packaging but generally feels the same) for several months. This silicone went out when the corona hit. I paid about $24 for the same amount of molding fluid that you get in this kit. I wouldn't turn this product down for anything, so far it's my favorite of the clear…

So the beauty of this product is that it is thin and stays that way for hours, keeping it relatively bubble free as described. When attempting to make cube molds, my 3D printed acrylic craftsmen cause a chemical reaction and prevent the silicone from curing, leaving a thin sticky layer around the cubes. I don't have this problem with other silicones like Sorta-clear 12. This silicone also doesn't seem to cure when applied to certain epoxies, glues and other plastics, so I'd count on it if you…

Curing seems to be a common problem in these reviews. Like everyone else, my molds never fully cure no matter how long I leave them alone. I tried to solve this problem by pouring several coats and letting them dry before adding more. This strategy didn't work as the sides of the mold weren't fully set yet, so I cut off the outside edge and found that everything was fine on the inside. After reading some other reviews hoping to get some advice people have said that this particular silicone…