🖥️ Enhanced Performance PCV Valve Grommet by Standard Motor Products GV6 Review

Overall quality is there but the gasket had to be modified to allow the crankcase ventilation (CCB) to fit properly in the gasket when installed in the valve. Glaze. I had to use a Dremel wood cutter wheel to make the groove a little deeper on the flat side. When installed before modification, the center hole was not round but teardrop shaped, so the CCB would not fit.

WILL NOT FIT 1972 Cutlass Supreme with SBO 350 standard valve cap as advertised. The bushing is OK if it is installed correctly. The outside diameter of the two corners of the bushing is too large for proper installation. I used a Dremel tool to sharpen them considerably until they fit as I found it easier than returning and ordering something else. Identifier specified (1").

Claimed to fit a 1965 Oldsmobile Starfire. It fits the port side of the valve cover, and the PCV valve which is a large one canister is inserted into this sleeve. The hole is too small and when you try to insert the PCV valve into the sleeve it tends to push the sleeve into the valve cover. After a lot of work and silicone spray I got it done, hooray! After about a month I noticed that the PCV valve was barely seating. The bushing was distributed almost entirely around the rim, hanging into the