🔌 Plug N Play Start-X Remote Starter for Toyota RAV4 2013-2018 Key Start Review

The kit had everything I needed and the instructions were very clear and included a YouTube link to show the installation. The only small issue I had was that the lock button took 4 clicks instead of 3 to work, but that doesn't really matter, works great

After reading reviews of other companies with remote start, this one convinced me. Installing on my 2016 RAV4 literally took less than 15 minutes to install without removing a piece of plastic. I followed the video on this site and it worked right away. After that I hooked up the TPMS so I could use my key to unlock the doors after starting. The best product I have ever bought for my car!

Works great, easy to install, a bit difficult to find the 3 button press rhythm but no problem. From time to time, he decides to turn on the check engine light, turn off the rear differential, and turn off traction control. There must be something wrong with the wiring in my kit, but luckily it can be reset with the $10 OBD2 connector and works fine. Only happens when starting and never while driving.

Toyota Rav4 2015 with IGNITION KEY. EASY TO INSTALL! beginning to end. I recommend you watch the video and follow the step-by-step instructions. So when you play the video the instructor in the video says do it, stop the video and do what he just said. Then continue with the video and complete the installation step by step. I couldn't be happier with this purchase and product. I highly recommend it

The straps were easy to install once you removed all the plastic panels. I also spent time routing these wiring harnesses, particularly the TPMs I routed through the carpet and center console/splitter. When you get to the programming steps, it starts the moment you connect the main wire harnesses. It is better to connect the ignition first, and then the other harness, and then programming is easy (follow the instructions in the book). Other than that, it works like a charm.

Installation took half an hour. It was easy to connect. Most of the time was spent tying up cables, installing and reinstalling panels, etc. I didn't see any in the video. After the vehicle is remotely started, the TPMS (Tyre Pressure Monitoring System) indicator will flash until you "take control". It's not a problem, but it bothered me until I found out it was normal. After you take control, the lights go out. If you apply the brake before the key is installed and click two clicks forward…

Worked exactly as shown in the video. I have been professionally installing vehicle electronics for over 20 years. It was an easy fix for a friend's car that needed a remote start. The only issue I could see was that on a Toyota with the auto lights feature, the auto lights would not turn off. The driver's door must open and then close to turn off the light. Or the vehicle has to think it's happening. They thought about this problem but the system I had had to be for a right hand drive car as…

More like 3.5*, the installation was easy and the video was perfect. It seems you need to find the rhythm by pressing the button three times to get started. That was excellent. But frustratingly, when it doesn't start you have to start over. Too bad there isn't a two-way launch confirmation option for the same setup. I didn't even know what that meant until I installed this device. There is a bug with the tire sensor, it turns on and off as soon as I get it going. It took me a few times to…