🛵 TC-Motor 15mm Carburetor Carb with Red Air Filter, Manifold Inatake Pipe Inlet, Alloy Stack Kit - 2 Stroke 33cc 43cc 49cc 50cc 52cc Engine Goped EVO Gas Scooter Cat Eye Pocket Bike Review

Let me start by saying that I would have given it 5 stars but unfortunately not all the parts were there when I received it. "Stack away." Contact the company and they will send me a new carburetor. However, I fitted a carburetor with no "stack" which gave the Goped a good boost.

The carburettor is a good replica, I drilled something through the plastic piece between the carburettor and the engine on a Bladez Moby xs33, had to cut the red plastic to fit, but everything else went smoothly! Definitely a useful performance mod after replacing it with a stock 10mm carb.

Woke up my 49cc Uberscoot X2. The top speed has been increased from 30 km/h to over 50 km/h. I haven't really tried to push it further because I can't find a sufficiently direct way to do it. I've seen relic posts online that mention a 16mm carburetor for this scooter but it doesn't seem to be available at the moment. It would also cost 5 times as much. It is 15mm and works very well.

Holly Molly! Best buy of 2019! I'm a heavier guy and with the stock carb I didn't have enough power to get top speed. Now it's in the past! Much better bottoms and faster to the top. This mod definitely increased top speed and was incredibly easy to install. I'm not a machinist and I don't know much but it was really easy and by far the best money I've invested in 2019!

Uberscoot 49cc scooter. It was pretty much "wrong" with the stock 12mm carb and airbox, but after installing that carb and filter all I can say is WOW! You need to route the included small flap. I used a thin washer between it and the damper and it worked great! You'll have to turn the mixture screw in a little to get it right, but once you do, be in for a surprise!

The picture I've attached is of my old carburettor, if you can get into that area there is a gasket - use it! If you break the top of the throttle body there is a rubber washer - place it between the speed stack and the choke lever - it will hold the choke in place. This carb works great - the only thing that bothered me was a loose choke - it rendered the carb inoperable - the mod above makes it great!

I installed this carburetor in less than 15 minutes and with a little tweaking my 49cc 2-stroke scooter was ready to go. Wow, how this carbohydrate has changed! I can't tell you how happy I am that I bought this. I searched for weeks and read all the reviews of over 50 of them on multiple websites and finally decided to pull the trigger on this one. Now I can replace the sprockets with something that will give me higher revs as my scooter didn't have enough torque for that unlike the previous…