TCMT Footrests Yamaha 2002 2014 2003 2012 Review

Perfect for my 03 R6 Easy installation without instructions. good quality, especially for the price, I will buy again if needed!

The footpegs fit my bike perfectly, although it doesn't say it's for my bike (2017 R6), I only knew Yamaha has it has not changed over the years for which this product was intended.

I put on my 2014 Yamaha R6 and snapped off the pin on the derailleur side and they fit like a glove and are easy to install very happy with them and they hold up very well

I had to reuse the pin that goes through the pin holder and secures the locking ring at the end. The supplied pins were about 1 mm too short. The rear pegs took a few tries to figure out and I'll probably go back there and add a washer on each side as the passenger pegs seem a little too roomy in the bracket. hey it works and was cheap so i'm happy.

Works great. The spring included in the kit works well, has good tension. The only thing I would recommend is using an angle grinder to trim your old OEM pins as the pin doesn't come off easily. When you cut the pin, you can cut the pin in half. After that, it's easy to install a replacement because all the pin holes match. The pins are also labeled left and right for your convenience.