🔦 Compatible Driver Side Replacement Signal Lamp for TOYOTA 4 Runner - TYC 12-5230-90 (without Daytime Running Lamp) Review

Perfect match for my 2004 4Runner Installed in less than 10 minutes. The auto parts store wanted triple what I paid for this one.

The lens itself is suitable but the connector is 2-wire and 2003 is 3-wire. Wiring aside, the 2003 model's connector is much larger and has different protrusions, making it incompatible.

They will not fit factory bulbs unless you upgrade to narrower LED bulbs. Don't waste your money. I had to drill them out and then use duct tape while you can get new ones.

Good deal not quite OEM but for $10 what do you expect. Surprisingly, there was even a lightbulb. I noticed there was condensation on it, but I dried it out and didn't see it come back.

NOT SUITABLE! Light female / male do not match! 2004 4runners. The bracket fits onto the truck with a screw. So you think everything is fine until you turn on the lightbulb.

Bought new, went in very easily and appeared to be a good product when purchased. After about 2 weeks I noticed condensation which has been going on for over a month now. . I took it apart to check for damage. This is perfectly normal. I don't recommend these bulbs as they look just as bad as the old ones due to the constant condensation on the lens.

This is for a 2 pin socket NOT a 3 pin socket. may NOT be for SR5, Sport or Limited. Try this instead for a three pin socket: https://www.amazon.com/Crash-Parts-Plus-Halogen-TO2532113/dp/B01MYX9JCT or this https://www. amazon.com/Drivers-Signal-Marker-Replacement-8152135391/dp/B007TYKDOIS See my photos. LEFT is a 3 pin hole, RIGHT is a hole for this item