Header banner
Revain logoHome Page
๐Ÿš— tyc 700188 toyota tacoma blower assembly replacement logo

๐Ÿš— TYC 700188 Toyota Tacoma Blower Assembly Replacement Review

5

ยท

Very good

Revainrating 5 out of 5ย ย 
Ratingย 
4.8
๐ŸŒก๏ธ Engine Cooling & Climate Control, ๐Ÿ› ๏ธ Replacement Parts

View on AmazonView on ะฏM

Media

(4)
img 1 attached to ๐Ÿš— TYC 700188 Toyota Tacoma Blower Assembly Replacement
img 2 attached to ๐Ÿš— TYC 700188 Toyota Tacoma Blower Assembly Replacement
img 3 attached to ๐Ÿš— TYC 700188 Toyota Tacoma Blower Assembly Replacement
img 4 attached to ๐Ÿš— TYC 700188 Toyota Tacoma Blower Assembly Replacement

Description of ๐Ÿš— TYC 700188 Toyota Tacoma Blower Assembly Replacement

OE-comparable assembly complete with motor and fan (wheel) to save installation time and cost. Superior materials and sub-components provide maximum strength and durability. The fan (wheel) is pre-balanced with the motor to ensure perfect fitment and performance. New (not refurbished), application-specific motor ensures maximum thermal efficiency. OE-comparable wiring harness, no 'pigtail' connector.

Reviews

Global ratings 5
  • 5
    4
  • 4
    1
  • 3
    0
  • 2
    0
  • 1
    0

Type of review

Revainrating 5 out of 5

Easy installation. Suitable for heating

2006 Tacoma. Arrived well packaged. Installs easily. Make sure it is properly aligned/flush before screwing it back in. No louder than OEM. It's noisier than the motor you're replacing as chances are one of them will fail and barely move air. My intuition (scientific term) tells me that this is a smaller move than new stocks, but not by much. I'm replacing the cabin filter to see if that helps improve airflow. You'll need to reposition the plastic cable retention tab, but overall this is anโ€ฆ

Pros
  • Beautiful packaging
Cons
  • Update Availability

Revainrating 4 out of 5

Good fan, easy installation

Installed yourself in about 30 minutes, including selection of tools! Works a little louder than the factory original, but not bad; I'm sure I'll be able to ignore this noise in a few days (you know how it is when there's a new noise in the car, you hear it). Also, I'd rather have a slight hum from a fan than a creak from a bad bearing, so the original was replaced. For $40 versus $114 for the OEM version, I'd like a slightly louder fan. Be warned that the small white plastic wire retentionโ€ฆ

Pros
  • great product
Cons
  • There are new competitors

Revainrating 5 out of 5

Don't listen to the bad reviews

I was in a hurry to buy a new fan motor for my Tacoma 07 because the original motor sometimes didn't work. This item arrived the day after I ordered it, just before I went to an anime event with my wife and some friends. Installation was very quick; three screws, disconnect one cable, and then pull it out. Some buyers report "high-pitched noise," but it's not a high-pitched sound at all, as loud as the Tacoma hits the road, you won't even notice the noise this engine makes. The noise soundsโ€ฆ

Pros
  • Easy to read control panel
Cons
  • ---

Revainrating 5 out of 5

2007 Tacoma fan assembly - perfect fit, easy install, no problem - so far

Replaced 2007 factory fan that would not run at any speed other than HIGH. No, in this case the problem is not with the fan resistance. The original fan had over 200,000 miles of air through it and the commutator was simply worn out. I ordered a new fan on Sunday, it arrived late Monday evening = WOW! The installation process took about 5 minutes. Fan. Disconnect the 2 wire harness hangers. Remove 3 5.5mm hex head screws. Pull out the old fan, put in the new one, and zip everything back up. The

Pros
  • Lots of positive vibes
Cons
  • No power

My 2008 Tacoma is 11 years old and had a problem with an intermittent fan motor problem four years ago in 2015. I completely disassembled the fan and repaired it every year, filed the fan motor stator and contact sockets, it worked perfectly for 12 months after each repair. When the new solid state resistor board came out I finally decided to replace both the resistor and the fan motor. The only problem was getting to the two screws that hold the resistor to the footwell. I highly recommendโ€ฆ

Cons
  • Cable is shorter than other options