🔍 Ultimate Rearview Mirror for UTVs: Universal Roll Bar Mount 1 1/2"-2" - Kawasaki, Polaris, Honda, Yamaha, Kubota, John Deere - 98310 Review

The mirror has a good look and will work great. Installation is easy, but if you have a 2021 Honda Pioneer without a windshield, it's flexible. I used a small fern and a spacer. I'll take it off and try some extra padding and maybe a few turns of tape to make it sturdy. Without her, she will be blown away by the wind.

Cheap Junk. I think you get what you pay for. Screwed as firmly as possible to the roll cage. It doesn't vibrate on the steering wheel, but it rattles on the adjustment ball and WILL NOT. BREAK. ROOM! It must be legal on our trip. Now it will fall off and I need to buy something better. Do yourself a favor and skip the step of buying this mirror before you buy something better.

Bought for my CT Moto 950 Sport, it fits well and seems to hold up on rough terrain. The only thing that bothers me is that it moves very slightly from left to right (displacement). I thought it might move while riding but it doesn't, the up and down movement can be adjusted very tightly so that's good. I hope that makes sense. Also the clip on it is quite unusual, it works perfectly but it doesn't get stuck on one side like it doesn't fit or you have to pad or remove the padding but that's how

I liked this mirror, its pot life was amazing and it was quite stable. But he will break! This is dangerous. It's not the manufacturer's fault, I took it off and when I put it back on it fell off and there are tiny pieces of broken glass everywhere. Since I'm using this in crawlers where tipping is common, I can't risk going back to it. You need something hardened or impact resistant. I'm afraid that if it rolls over it will be hit by a rock or something and the glass will get in my eyes or my…

Putting another rubber band on the front tractor bar caused the parts supplied to move apart a bit. Tightening the nut against the included bolt caused the nut to loosen (soft alloy and threads). When tightened further, the nut turned in the plastic (too soft). It will require gripping the nut with pliers to tighten the nut and bolt - and hopefully safe now. Not sure how long the mirror will stay in place given the vibrations from the tractor. I'm not sure why the country of origin or country…

Installed on my 2021 John Deere Gator XUV590M. Installation wasn't as easy as most clip-on models, as a rubber spacer needs to be installed while the mirror is held between a plastic clip and two plastic spacers while the nuts/bolts are installed and tightened. . It's not terrible to install, but two people are definitely recommended as there's so much to hold and also try to place properly. This design could have been made a lot easier with a clip-on mount. Overall, the mirror is very nice and

The mirror offers a wide panoramic rear view and I like the single center mount more than the double mount on my previous mirror. When choosing the grommets I had to experiment a bit to find a combination that worked for my crossbar diameter, but other than that the installation was very easy. Some reviews mentioned that the mirror would not stay adjusted and I turned to what I think is causing this problem. I don't think it's due to the lack of holding power between the clamp brackets and the…