Header banner
Revain logoHome Page
uro parts 037121010c water pump with metal impeller - no thermostat & cover logo

URO Parts 037121010C Water Pump with Metal Impeller - No Thermostat & Cover Review

3

·

Average

Revainrating 3 out of 5  
Rating 
3.0
🌡️ Engine Cooling & Climate Control, 🛠️ Replacement Parts

View on AmazonView on ЯM

Media

(1)
img 1 attached to URO Parts 037121010C Water Pump with Metal Impeller - No Thermostat & Cover

Description of URO Parts 037121010C Water Pump with Metal Impeller - No Thermostat & Cover

Equipped with metal impeller for efficient flow and greater durability (OE plastic impellers can shatter and clog cooling system passages with broken pieces). Guaranteed fitment. Manufactured to OE dimensions for easy installation and proper pulley alignment. Constructed of high-strength alloy and composite materials (where applicable). Quality bearings and seals for long-term reliability.

Reviews

Global ratings 3
  • 5
    0
  • 4
    1
  • 3
    1
  • 2
    1
  • 1
    0

Type of review

Revainrating 2 out of 5

worth spending $50 elsewhere

dies after two and a half years. The pump is leaking like crazy. It just so happened that 6 months have passed since the end of the warranty. very disappointed!

Pros
  • Equipped with a metal impeller for efficient flow and longer durability (original equipment plastic impellers can crack and clog cooling passages with dirt)
Cons
  • functionality

Revainrating 4 out of 5

Good pump with 'problem areas'

Really great looking pump. Not sure if the bearing and pulley are fully pressed in as per previous reviews. I have included photos of the pump and photos of problem areas. It looks like the bearing is not fully pressed in and therefore the pulley is not in the correct position. Today I'm taking the pump apart and putting it on an arbor press to see if I can press the bearing where it should be and to make sure the other components are in place.

Pros
  • Manufactured to OE dimensions for easy installation and proper pulley alignment
Cons
  • Defects

Revainrating 3 out of 5

good molding - poor workmanship

The first thing I noticed when I received this was that the hub to attach the pulley to the impeller axle was not tight enough. Comparing this to my old pump, I found that I couldn't start the pump because the hub was too far away and could mess up the belt line. I was lucky though as my old pump is in fantastic condition and I just needed a new case so I replaced my old pump with this new case and have been using it ever since. Everything seems fine and as I said the casting looks really great

Pros
  • Quality bearings and seals for long term reliability
Cons
  • I will add later