Anzo USA 511050 GMC LED Parking Light Assembly in Black - Pair Review

love how it looks day and night. had to do the old turn signal trick and cut one of the solder/wires on the turn signal relay board because of the hyper flash of the LEDs. The rest of the installation was easy. It's also been raining for about 3 weeks and not a single sign of condensation inside the case so it's sealed fairly well but I can just put on an extra layer to make sure it never loses its seal like they do.

Nice looking lights but not plug and play. The product doesn't account for the drag difference for the older truck so you have a hyperflare. You will need to buy resistors, aka equalizers, for each of the assembly's terminals and connect them directly to the assembly's terminals to ground and the turn signal wire. And maybe a flasher relay designed for LEDs. In all, I spent another $60 to get them working properly. The materials are not very good, but they do the job. Be careful when screwing…

Perfect brightness. Expensive for the body material, the lens seems to hold up normally. Everything fit into the car with no modifications, although some parts were a bit tight. Mine came right out of the box with a broken corner of one of the parking lights but I installed it anyway as the screw was still able to hold it and going back to the Revain is a bit of a hassle as I need that road. -Ready and safe for night driving. Ambiguous statements, you should be able to wire them however you…

They looked amazing when they got here and when I looked closely I realized there was something wrong with them and I couldn't figure it out. Installation was pretty easy but I had an alignment problem, but I don't know if it was due to the new post Maket grille I had fitted or the lights, but they didn't fit without an adjustment after the fact and when I did Turned on the lights I found out why they turned their backs on me. I was sent 2 side lights on the driver's side so I have the main…

Got this for my 99 K1500 Suburban. They are installed like standard lights and connected directly to the wiring harness of the old light. The LED turn signals are polarized so you may need to rotate them 180 degrees for them to work properly. In addition to the included resistors, you will also need an LED flasher block to avoid the hyperflash problem. I've posted a video of my wiring solution if you have all 3 (Anzo headlights + these + LED turn signals). Also, these are great lights and they…

Blown fuse because the wires weren't fitted with protective covers or something to prevent short circuits. As soon as I opened the box the paint was still wet, I appreciate how quickly they arrived but not so much that the paint was still wet. The instructions were ok, as a beginner it will be difficult. But the main issue was how cheap the cables were and had no protection. The wires rubbed against the inner case and metal causing my LPS fuse (license plate light, taillights and dash light) to

The cut and finish is amazing. Running lights are exactly what I was looking for to update the front of my Tahoe OBS Precursor. Seems to be a quality control issue. After removing and installing the grille to the specified grille, I proceeded to install from the driver's side and the LED bulb sockets are missing the ear caps shown in Photo 1. These caps not only reinforce the silicone wire connections, but also allow users to physically screw the electrical connector into the lamp socket. The…