🔧 Compressor Center: Advanced Utility Pressure Gauge Review

I bought this to install on the pressure regulator for my two stage compressor. I didn't want or need a liquid filled gauge as it wouldn't be affected by the pulses of a running compressor. The sensor responds smoothly to the use of air, easy to read dial. I don't expect to be able to move it from the 90-100lb setting, so I can't comment on other print accuracy. . 5 star rating so far. I will post an update if this changes.

Bought these to check the pressure on my inflatable kayak. Since I have 2 adapters, I bought 2 of them. Box: One does not fall to the bottom of the range without applying pressure. They differ by 1.1psi in readings when the measured pressure is between 2-3psi (don't know when higher). The other died (does not read print) within 5 minutes of first use. I will send them back.

Media could not be loaded. I replaced an air knife on the nail gun compressor tank. This 2 inch gauge was slightly larger and only rated 160 psi. (Replaces 1.5" 0-200 psi gauge) but since the max air pressure is 120 I figured this one would work better. Immediately I noticed the needle vibrated back and forth and got really bad as the pressure increased reached almost 120psi. The one on the air regulator is smooth from start to finish. So you can only get an accurate reading of this air gauge…