Front Windshield Washer Nozzles Kit | 7T4Z-17603-A 7T4Z-17603-A-JET | Compatible with 2007-2011 Edge, 2007-2010 Lincoln MKX | 2 PCS Spray Jet Kit Review

Nozzles are inexpensive and fit well. Quick installation if you have a hood trim tool kit. Unfortunately, the sterilization sheet is terrible. It only sprays washer fluid, not the pattern covering the window.

I had to slide cardboard under the nozzle to keep it upright. Now only one side is fixed. Now it splashes in the middle of the pane, but had to be changed. Simply fixed, they literally splash onto the window floor. Wouldn't buy again. Probably wrongly formed. I won't be going back, not worth my time at $8. It's enough until I find a local replacement.

Item OK overall good installation but there was a problem with the nozzle setting. Both atomizers basically squirt water straight onto the front of the windshield and aren't easy to adjust, if at all. With a lot of effort and sticking a paper clip in a small hole, I managed to splash water on the windshield. I wouldn't buy them again.

They were for the 2010 Edge Limited. Easy to install and perfect fit but they are very disappointing as they don't direct liquid onto the windshield. The spray mainly covers the hood between the nozzle and the wiper. I would not recommend them. Replaced them with regular Ford injectors. Didn't send it back as it wasn't worth the hassle. I disposed of them properly in the trash can

This product does not meet OEM standards and as such cannot be installed. Installation requires a small flange on the pipe that is inserted into the service pipe to engage a sleeve that locks and holds it in place. This flange is too small and will not snap properly. OEM parts that need to be replaced due to clogging can be installed normally. Don't waste your time.

I drive a 2007 Ford Edge and the two original washer nozzles that came with the kit have fallen apart. This product is hard to find and I was lucky enough to find it at Revain. I bought a set of two attachments, but only one of the two attachments worked properly. Now I'm buying a second set in hopes that one of the two will work properly. Please note that once installed in the hood, the nozzle can only be removed by breaking it apart. A return on credit is excluded from this.

I bought these parts because they matched exactly what I needed to replace on my 2011 Ford Edge. Unfortunately, only the optics fit. They fit well and fit well on the hood of the car. The jet of the nozzles is very bad. The nozzles are unrestricted so that no pressure can build up and the liquid hardly reaches the windscreen. Difficult to access from the passenger side due to pressure issues. The driver's side doesn't fit. Don't buy this. It is better to buy something suitable from an auto…