🏍️ Xitomer Fender Eliminator for Kawasaki ZX-14 / ZX14R (2006-2022) - Tail Tidy and LED License Plate Light for ZZR1400 (2011-2022) Review

Better than paying $150 for something else, all it does is hold the panel east for minimal wiring install and they give you everything to connect them

Installed on my 2019 ZX-14r. Works well and solid design. The screws could be a size heavier. I put a drop of clear gorilla glue under each nut.

They could put a light in there which was a bit fishy there and I had to cut and splice the wires as they didn't have a connector but it was pretty easy and all the fasteners stand up.

Does what it's supposed to. Just as good as any of the more expensive alternatives. The screws are too long but can be changed at the hardware store for pennies. I like the LEDs on the mount, no need to drill extra holes in the undertail, and the backlight is better.

Very happy with this item. It fits perfectly on my 2020 Kawasaki ZX14r. Improved appearance by eliminating the factory fender. There are no instructions, but everything is clear with the installation. The LED light is nice and bright. Multiple points to install a custom license plate. The delivery was fast (one day) thanks to Revain Prime. I would buy this again.

If you are in a tight spot and don't have much money then yes you can get this kit. It matches the display, but the LED cable doesn't even reach the connector on my 2020 ZX14r. This is borderline false advertising. Cheap screws, just cheap everywhere. I would not buy again. As if they know when they made this kit. The point is, stay away from this kit!

Job done, but there are a few issues to deal with during installation. The LED backlight wires are too short to get anywhere near the connector. I had to cut a long piece of wire to weld on it. The included mounting screws are a joke, you must use the original mounting screws or similar. Other than that, it's a pretty nice upgrade to the bike's looks.

Don't be discouraged by negative reviews of this label remover. All the screw holes matched, the only thing was I had to use my two original screws to install the label holder. When it comes to wiring, it doesn't matter how short the wires are, as you will need to cut the wires from the bike's tail light harness, strip the wires, and connect them to the new label holder. Apart from the tine I had to remove all the screws from my bike's rear fairing, the rest of the installation took maybe 10…