📦 Pack of 8, 6-Inch Solid Steel Floating Shelf Brackets - Concealed Hidden Supports for Black Wood Shelves - Includes Screws and Wall Plugs Review

Very powerful and well done. a pie with very simple instructions for installing shelves along with drywall anchors and lots of screws. I used a 1/2 inch long bit to make sure the brackets went in just enough and were flush with the back of the shelf. Just make sure you don't drill too deep and through the other end! I took a shackle and periodically checked the depth of hope as I drilled.

Very strong and sturdy. But as mentioned in other reviews, their length varies slightly. But if you drill your own holes for the shelf this shouldn't be a problem, just drill a little deeper! But if you're trying to hang the shelf on the wall, you'll need to use more than one bracket. A whole different story! It is very difficult to like everything and align the shelf. It takes a while, but you can do it! Rschunimagu

Item I bought for my daughter who is going to college for her new pillow. I didn't expect the holes to be an inch and a half apart. So when you find the stud you can run the screws into both sides of the stud and not in the middle like you should. I would look elsewhere, it's too difficult to get the two screws of the brackets to both hit a stud in the wall (like you should for something heavy). They're well made, just badly designed.

Let me start by saying that I have more craft experience than most and am always up for a challenge. These mounts are good value for money, but they do have their downsides. As previously mentioned, the recommended installation (also as shown in the attached installation guide) is not possible with 2x4 wall studs, so the holes must be aligned vertically. The baseplate is 2.1-2.2 inches wide instead of the advertised 2 inches. This is important because unless your floating shelf is that thick, a

In theory this product makes sense, but in practice it's quite difficult to use properly. There are several issues proving this: 1. The finish isn't very consistent - the angle of the wands is slightly different for everyone, meaning you'll need to put some of them the right way around and flip some to get them all lined up the shelf you are standing on in the middle. Installation (assuming you pre-drilled all the holes in the exact center of the shelf). I don't think this is intentional and…