🚀 Highly Efficient Creality Original 3D Compression CR 10Mini: Unleashing Limitless Possibilities Review

Bought these for my 2020 Ender 3 Pro. Very easy to install and only took four so I have a spare. They are much better and stiffer than standard springs and definitely keep the bed level better than standard springs. I've since added an automatic bed leveling sensor so this isn't an issue anyway, but I'm hoping these springs will keep my bed pretty close to what I set the bed to the last time I manually leveled it and the limits of my ABL have not tested .

New to 3D printing, after having trouble keeping the bed level (or what I thought was bad just had to raise the nozzle temp) and had a lot of failed prints, I ordered them and they work However, in my case with the Ender 3 V2, I had to raise the Z-axis switch because the fully compressed platform was too high and scratched the platform plate. The Z-axis plate is a small switch on the left side as viewed from the front of the printer and is held in place by two T-nuts. You may need to fine tune…

The printer arrived very well packaged. Assembly was pretty easy if you watch a few YouTube videos as the instructions provided are not clear or go into much detail. The parts are well made and actually come with a few extra screws that I never get. No tools are required other than the tools provided. It took several hours to assemble, and several more hours before I had the confidence to start printing. I read beforehand that heavier springs are recommended for a heated bed, so I ordered…