Gizmo Dorks Blue Painters Printers: Superior Performance and Precision Review

When they say it has tack, that means it has tack. Make sure you place these things the way you want them. The role I got just doesn't want to let go (which is good). If you're having trouble staying on the table when 3D printing, this will likely help, but if you're not standing upright and printing too close, good luck getting your print off the table. This tape really holds up. Having properly leveled my bed and properly reduced the initial layer height, I no longer use this material. It's…

I was looking for a way to get more printer bed adhesive for my buck, it was a sure win. At 6.25 inches by 100 feet, I can cover the mini bed over 1900 times. Since most sheet packs come with 810 sheets for $1520, it just makes more sense for longer term use. This amount of tape also allows me to change beds as often as possible if, for example, I feel the previous print has worn off, rather than wasting the entire run trying to "just take another" off the sheet to get. The material adheres…

I like the size because it allows for faster build plate alignment. If it's on the plate and starts to heat up, the glue will soften too soon and won't curl well. Much worse than the cheap Lowes blue masking tape. BUT what is good is the texture and adhesion for your prints. I've had excellent adhesion with PLA, ABS and PETG, in fact PETG was so good that even with a wire brush and water I couldn't remove half the tape from the bottom of my print. Good thing it was a proof of something. I found