🛁 iDesign Gia Metal Grid: Ultimate Non-Skid Sink Protector for Kitchen, Bathroom, Basement, Garage - Polished, Set of 1 Review

I really liked the look of this sink protector. It turned out to be durable and attractive. However, it didn't fit my sink properly. I measured before buying and was sure, but my small double sink is slightly tilted towards the center drain and the legs don't touch the floor. Instead, the web rested against the walls of my sink. I knew that the walls would scratch the sink over time, so I bought a different product. If your sink doesn't have a FLAT bottom, this grate won't work.

These shelves fit in my sink and solve the long-standing problem of rubber mats keeping food sticky and getting moldy and slimy if you don't constantly take it out of the sink and clean it. Unless you're shipping something really big, they don't need round drainage holes. The mesh allows most food debris to wash away, but is small enough to prevent cutlery from going down the drain. The racks are strong and won't bend when you put a pot on them, and the legs are smooth. Too bad I didn't find it

I have had two 11 x 13 screens side by side in a large sink for about 8 months. At first I liked her. They looked good and worked well. Unfortunately they started to rust from below. They won't rust where there are rubber capped legs. They rust along the four outer parts that make up the mold. This product is advertised as stainless steel and will not rust. This is an incorrect statement. Expect it to rust eventually. Now look for the same vinyl coated version. I am very disappointed with the…

I love these racks! This protects my stainless steel sink from scratches, and I can also wash vegetables, chicken, etc. in my sink and let them drip directly onto the shelves. I've also used them for breading chicken and pork chops - I bread the meat and then place them straight into the sink on the wire racks while they wait to be fried. Clutter is so easy to clean up! I can also let the dishes dry on these racks. All of this is possible because these baskets fit in my dishwasher, so I can…

I was looking for a replacement for a vinyl lined wire basket that was made specifically for my sink. Over time the old basket rusted and I opted for stainless steel. This sink grate looked like a good replacement, but due to the odd shape of my double sink (not rectangular) I wasn't sure it would fit. So I cut the measurements for this product out of cardboard, guessing the radii on the corners. My cardboard model barely fit, although too close to know for sure. When the InterDesign Sink…

Bought to fit my Ikea Domsjo double sink. Not perfect (needs to be lifted to get to the drain) but after trying forever to find the right one it's good enough and cheap. It protects my sink from my dishes and my dishes from my sink. The attached photo isn't the best, but you can see that you need to pull the guard well into the corner with the drain to get the sink guard's legs to lay flat. This will leave a few inches on the opposite side and forward. I was disappointed with this when I first…

I have an old cast iron double sink which means glassware is in constant danger unless I use mats on the floor. I've used rubber mats, but food and liquids always got stuck in the channels underneath and decomposed. Worse, my sink is white so I actually had to put bleach in to deal with the horrible stains that formed - cleaning with detergent won't remove them. So I was wondering if there is a way to avoid this problem - if there are sink mats that don't lie directly on the sink. I found them…