🚗 Nilight 6 Gang ON Off Rocker Switch Panel with Red Backlit, 12V 24V LED Digital Voltmeter, Dual USB Charger, Cigarette Lighter Socket, Overload Protection - Perfect for Cars, RVs, Boats (90122F) Review

Satisfied with the purchase so far. Bought for a 12V solar system in the cabin. It was very easy to connect and install. The switch backlight is very bright. In general, I have no complaints. Also, there were many options in the sticker pack, including some pretty fun ones like Bigfoot and Aliens.

When we started wiring, one of the switches broke. I thought I pushed too hard so I spent a little more time and was good and another one broke. I can't return it now! So I took the switch apart and tested it. Now I understand that I will not go on the water today and I lost $50 because I bought this POS and wasted all my time on it. Incidentally, the pre-installed cables can also be pulled out easily, you just have to look at them pft.

This switch panel is good but if you want to add custom actuators to your switches skip this one. The drive tabs on each switch housing broke when the drive was removed with the drive removal tool. I ended up spending another $120 on genuine Carling switch housings that have different wiring so I had to rewrite the entire panel. All said and done, I'd be better off buying a custom panel and original Carling switches. However, if you just want to use it as is, it works very well and is…

Good quality panel. Some items were lost. There was a gap in one of the switches. Maybe it's a sign for the future. Pre-wiring was good except it lacked basic attention to detail with loose parts and no grease on the metal parts, nothing was properly welded in to prevent water from rusting uncoated metal. Overall I would rate this 3 1/2 stars. I can't afford to lose power to any of my water switches due to corrosion. so there is still work to be done to treat this water and i'm not sure how…

Nice addition to the dash. I believe the rubber caps have resettable 3A push button switches. If so, then this is a really good switch. The switches glow VERY LIGHT BLUE which prevents melatonin production so be careful when entering the sleeping area. Green light, a little darker, would be ideal. The digital display and USB/accessory port also have a blue LED and are rotatable. I change the position because of the direction of the panel and where I wanted the digital display (under the edge of

I bought this to control numerous items in a work truck. Like many things from Revain, the packaging looked like it had been used for football practice. Surprisingly, there was no negative mark on the device. While the switch panel is pre-wired, I wish it wasn't. They are connected in series, which creates the possibility of a complete system failure. Note, however, that this panel will NOT charge the device, so the overall risk of failure is low. This panel can handle several amps, although a…

If you need to replace any of these with a different switch (navigation light or starter) know that cutouts have worked great for me with my existing Carling switches. Was it hard for her to get out? Yes why? They are made of hard plastic, did I break something? no Take your time and learn how to insert and remove these switches. TO UPDATE. However, do not attempt to replace the switch covers. I bought a set of badges and labels for various functions designed for Carling switches. EVERY…

Battery voltmeter went dead in less than 1 hour for a total of several days of short trips. Luckily for me, I didn't install it permanently, just carefully tucked it into my van's console hole. Had it hooked up to crocodile wires to see how it worked. Well it isn't. I had my doubts the first time I lit it. I had a precision lab voltmeter connected in parallel to see how accurate his LED battery voltmeter was. Well it's not --- it reads more than a full volt. Also, it was unstable and varied…

*UPDATE 17/06* I believe the problem I had with the contacts of the switches when wet was related to the gasket that goes between the dash and console runs. The supplied rubber gasket/sleeve is made of thin rubber and does not provide a good seal. After weeding out a few options, I realized that this was the weak link in the system. So I put some sea silicone around the edge of the slab. I've ridden it in the rain since then and NO MORE PROBLEMS with unwanted chain contact! Upgrading to 4…