🚤 Factory Matched 3-Inch Boat & PWC Registration Number Kit - Hardline Products Series 400 (Blue/Black) Review

I used this in combination with the Hardline Products Sticker-On! Decal Fluid, 2 oz. The combination made this product much easier to use. Pros - I like the look/style of the letters - I liked the cost - You get a lot of extra letters (I used to register a jet ski) Cons - Harder to peel than other non-fingerprint stickers. But if you fold them back and use the torn edge of the non-letter part (e.g. tear off the corner and peel off the sticker, use smooth paper as a tool). Overall - I would buy…

This is a great looking product and relatively easy to apply (although the numbers are a little tricky at first). My only concern is that its effectiveness depends on how many times the given number appears in your boat ID. In my case I had three sixes. This meant I only needed six pieces (since the number was supposed to be on both suitcases). There are only four in the set. Yes, of course, but I didn't get my boat pass from the government until after I ordered the stickers, so that was a…

I bought them for the newer Waverunner. I didn't want simple square letters with straight lines. In my humble opinion, they are of lower quality than the Attwood kits that Walmart sells, in my opinion, and cost $10 more. I think trendier means more expensive and cheaper. These letters are very thin. Make sure the wind doesn't blow when you apply them. Like a feather they sway in the wind. Some of mine almost went through the substrate they are on while stamping. Pulling became more difficult…