2-Pack Corner Shower Caddy: Wall-Mounted Stainless Steel 🛁 Organizer for Bathroom and Kitchen with Adhesive and Hooks- Black Review

NO DRILLING,EASY INSTALLATION & REMOVE: No drilling needed and no damage to wall,powerful adhesive comes with the bath shelf ensuring the shower rack stable,just peel off the film and stick it on the wall. Powerful adhesive offers strong bearing capacity,we also offer additional 4 adhesives to meet your needs, if you want to move the shower shelves to another place, just need to install adhesives.REMOVE GUIDE: Use a hairdryer to heat the sticker, tear it off easily when heat enough. SPACE ORGANIZER: These bathroom shelves are designed for organizing your space, ideal for storing your shampoo, body wash,soap and more. Not only can use them in the bathroom but also in the kitchen, bedroom, any place you want.4 hooks can hold the razor, towel, sponge, brush, and more.Note: Mrinda 2 Pack shower caddies only fit 90°right angle corner, NOT suitable for round corners.DO NOT stick the adhesive strip on painted walls or wallpapers as it will take off your paint or wallpapers. RUSTPROOF MATERIAL: MRINDA corner shower caddy made of SUS304 stainless steel, which made the corner shower caddies rustproof, stable, durable, and longstanding use. Avoiding rust stains on the floor or walls, keep your space clean and tidy.If it is rust during use or you have any questions, please feel free to contact us. DRAIN FAST: The corner shower caddy comes in an open-grid design for maximum air ventilation and water dripping away. Keep your bath products clean. The grid can prevent some small objects from falling. Our bathroom shelf can bear up to 30 lbs, DO NOT press the shampoo hard when you place it on the shower caddy. It might cause an exceeding the load-bearing limit. WHAT YOU GET: 2 different sizes,you will get 2 x shower caddies (large: 10.63 x 10.63 x 2.2 inches, small: 9.84 x 9.84 x 2.0 inches),4 x Hooks,8 x adhesives and 100% satisfaction customer service! Note: It is recommended to install the large layer first and put the objects you want to place on it first, and then install the small layer, to avoid the objects you want to put in after the installation is higher than the distance between the two layers.