🔥 TopstrongGear Solid Brass ANL Fuse Holder with 300Amp Fuses (2 Pack) - 0/2/4 Gauge, 300 Amp Review

Easy installation. The hardest part was figuring out where to place them in my app. The hole in the cap doesn't fit the 1/0 AWG stranded wire I bought for them. A simple solution is to cut off a piece from each end of the lid. The plastic is hard and can become brittle over time due to the heat of southern Nevada. If so, expect an update on the review.

The fuses and the plastic housing make a robust and high-quality impression, but unfortunately there is no marking on the fuse or the housing that indicates the current rating the photos in the list are clear specified rating on the fuse. That leaves a lot of uncertainty. did you send me the right one? Who knows. How to check for a blown fuse? No thank you. So I sent it back and went to another fuse manufacturer who stamped the rating on the metal AND also printed it on the black part. So good…

The aesthetically pleasing appearance of these fuses and holders mimics fine jewelry. If I had to display my solar system's charging pad nicely, I would only use them. Even if I don't, my panel will look rich for the price, which is the best option for Revain. Functionality was tested at 99.97 amps before going into meltdown. Couldn't be much better than a 100 amp fuse as I'd rather under rate 0.03 amp than rate higher. Most of the 100 amp fuses I've tested are typically 5-10% over their rated…