🔴 1/0 AWG Gauge Pure Copper Battery Inverter Cables in Red + Black - Ideal for Solar, RV, Car, Boat Applications - 12 Inch Length with 5/16 Inch Lugs Review

These cables were used in a solar generator project connecting a sealed 100 amp hour AGW lead acid battery to a 3000 pure sine wave AC/DC power supply converter. The cables carry the power needed and don't seem to get hot when power is present.

For my use I had to cut them off to put a shunt in the middle on one and a breaker on the other. Both showed copper strands of suitable gauge. I will definitely buy from them again. Technically already done, but if I need more, I know where to turn.

these guys have been sitting quietly between the batteries and inverter in my village solar system for a year. Billions and billions of electrons flowed freely through them. quality connectors at each end.

These cables look like high quality cables. Unfortunately, during installation, one end of every 1/0 cable I ordered broke. The clamps weren't tight enough to release the ends. Luckily I have a crimping tool and was able to crimp them properly so save my project. I expected more from "professional" crimped cables for the price.

Attention! Make sure both ends are crimped properly, the negative ends will come loose with a slight tug. It's only held in place by heat shrink tubing. I was happy about the positive and when setting it up after a week of use it also fell apart. Luckily I wasn't on the road and already got myself a crimping tool for another project. Otherwise they appear to be of good quality and have enough flexibility to accommodate awkward positions.

This is good stuff! I swapped out the battery cables because I switched to voltage sensitive fuel injection. With the old cables, the voltage dropped too much when the engine was started. These new cables keep tension where it should be. The ends are crimped and soldered to perfection, and the insulation on the wire is much better than the shiny plastic of some other manufacturers' cables. You can't go wrong with these cables!

High quality power cords used to upgrade battery to ground and generator power. I will order additional lengths to add bases if needed. These cables are true 1/0 gauge, well terminated with high quality welded in termination rings. This is seen as a big three upgrade that should improve the generator's charging efficiency. The theory here is that the load on the power plant is reduced because the alternator is doing less work to keep the system charged. More horses will be free to do what they…

I used it to move the battery in the trunk of my Nissan 240sx. They worked great and were the perfect size. I had a few minor complaints. I used to buy various cables from WindyNation. They aren't quite the same as the others I've bought. They are stiffer and have a tighter curve. No matter what I tried, the wire didn't take a more direct route. It wasn't a big problem for me, but I had to plan ahead. So if I wanted to route a wire from point A to point B, I had to make sure it matched the…