🚀 BETAFPV 1103 8000KV Brushless Motors 3S - Perfect Addition to Your Beta75X 3S Brushless Whoop Drone Review

These motors are great for 2S like Beta75X! They are lighter than most 1103 motors on the market because the bell design is very open. In fact, they are no heavier than my 1102 engines! When using these motors with BetaFPV 2S ESCs, they are wired without soldering. I am completely satisfied with the soldering, but I still really like this convenience! I suggest using the 40mm props that BetaFPV sells. They work great with these engines. You push the shaft and hold on. I do not recommend using…

I bought 2 sets of these motors for the mini octocopter. Even before I checked the engines, it was clear that something was wrong with them. They didn't spin like normal motors and felt like sand, like there was some dirt between the magnets and coils. I shook them and nothing rattled, so I'm thinking it must be bad, uneven winding of the copper wire. I was sometimes able to get the affected motors to spin smoothly for 2 or 3 revs before the problems reappeared, but I was unable to clear any…

. I just received these and installed them on my GEPRC phantom which had a dead motor. i was impatient and bought them instead of waiting for delivery from the fpv supplier because they were free overnight. They came here a day late and late at night, so I didn't do myself any favors with that decision. is due to the size difference. The screws work and the engine runs well but not perfectly. The cables on the motors are very short. When the plugs are removed, their length does not exceed 4.0…

After many failed Racestar 1103 8000KV motors bought from Chinese sites I decided to try these motors for my first finished build which is a 3D printed Prusa Tiny Tina Whoop was drone. These engines worked great and I was finally able to complete my build. They are only $1 each less than the Racestars bought by the Chinese and are of much higher quality. They are lighter, the cables are thicker and the cables are heat shrinkable as they exit the motor. One reviewer said there were no bolt…