Header banner
Revain logoHome Page
metra xsvi 1784 nav sprinter rap retention logo

Metra XSVI 1784 NAV Sprinter Rap Retention Review

6

·

Very good

Revainrating 4 out of 5  
Rating 
4.2
🚗 Car Electronics, 🚗 Car & Vehicle Electronics

View on AmazonView on ЯM

Media

(1)
img 1 attached to Metra XSVI 1784 NAV Sprinter Rap Retention

Description of Metra XSVI 1784 NAV Sprinter Rap Retention

Provides accessory (12 Volt 10 Amp). Retains R.A.Tpu (retained accessory power). Used in non-amplified systems or when replacing amplified system. Provides nav outputs (parking Brake, reverse, mute, and V.S.S.). High level speaker input.

Reviews

Global ratings 6
  • 5
    4
  • 4
    0
  • 3
    1
  • 2
    1
  • 1
    0

Type of review

Revainrating 5 out of 5

Very easy to install

Was working on a base radio replacement on my 2010 Sprinter. Replaced head unit with single din JVC. Very easy to install.

Pros
  • Impressive
Cons
  • Very expensive

Revainrating 5 out of 5

Great product for a '09 Sprinter aftermarket stereo

I really liked how easy and straight forward installation it was and even more loved the fact that they fixed what seemed a complicated aftermarket stereo problem that wasn't working in my 2009 Dodge - Sprinter of the year.

Pros
  • nice item
Cons
  • don't remember

Revainrating 5 out of 5

No wires were damaged installing a Killer stereo in a Sprinter

Works as advertised and easy to install. to aftermarket radio adapter for some 1988 to present Audi/BMW/Mercedes/SMART vehicles and Metra Axxess ASWC-1 Universal Steering Wheel Control Interface for Sprinter 2007 and newer! I hope you find this review helpful and good luck. For your health!

Pros
  • Works great for me
Cons
  • Zero

Revainrating 2 out of 5

There is no "speed sensor " wire at the output.

everything is ready for soldering. Put the wires where they need to be and you'll find that the speed sensor wire that the navigation radio requires only runs between the connectors and doesn't actually go to the radio. Not exactly excited about taking this thing apart and reconfiguring it. Also the connectors for the CAN module (or at least I assume so) and the steering wheel control module are the same connectors. A really short-sighted design decision. Overall I would return it if I had time

Pros
  • trial period for one year
Cons
  • i will write later

Revainrating 3 out of 5

Might fit, but there are better straps for the 2014-16 Sprinter.

Description "07 Up" is imprecise. It might say "07-13" on it (I haven't checked the earlier models, but I know 2014-2016 Sprinters have more suspension). I have a 2016 and I first ordered this harness to find it was only a partial insert. The onboard wiring harness connector is much larger. The pinout is the same halfway through the board harness, so you can hook up the entire XSVI-1784 and it will likely work. However, they don't have a snap lever (so you'll have to glue or tape it on). There…

Pros
  • New
Cons
  • I don't really like it, everything is fine

Revainrating 5 out of 5

2008 Dodge Sprinter RV

Installed in a 2010 Winnebago View (2008 Dodge Sprinter Chassis) with Home/Engine Battery Switch, the installation was the most "advanced" car stereo I've done to date. but in the end it worked out great. My Sprinter doesn't have a steering wheel remote control and therefore no CAN data bus line in the stereo wiring, that was the tricky part. There was a workaround mod I would never have figured out without Axxess' top notch support. Two calls to her office were answered immediately by a man…

Pros
  • Lots of Positive Vibes
Cons
  • Long Delivery Time