Review on High-Performance Transmittance 🚀 Strength Thick & Compatible Replacement by Anthony Gupta

When your prints are no longer adhering to the build plate, there are usually two reasons: (1) the tension of the FEP film is not tight enough; Solution: Tighten the FEP with the screws on the bottom of the tub and use the smartphone spectrum analysis app until the "ping" spectrum reaches a peak frequency of 450 Hz when pressing the FEP. (2) FEP becomes cloudy and rough after 25-40 prints. Movie Stars Solution: Purchase the above and replace the FEP! Anycubic has a good YouTube video on swapping (don't forget the bottle cap gasket!) and you should be able to do it without hesitation and it takes 5 minutes. 5 minutes and $2 per movie versus misprint after misprint? 5 minutes anytime!