Review on 🌳 JeCar Limb Risers Kit - Hood Protective Sub-line Branches Brackets for 2007-2018 Jeep Wrangler JK JKU, 2PCS - Exterior Accessories by Darren Neal

product exactly as advertised. The product appears to be of excellent quality. Installation is much easier than it looks and requires drilling 3 holes on both front door pillars at the top of the pillars. I place the top 2 anchors as close to the top of the post as possible. I marked the holes to be drilled with a white pencil. I used an awl to cut out the dent where the holes were going to be drilled. This ensured that the drill bit stayed exactly where the holes needed to be drilled. The holes in the anchors are 5/32 and the included rivets are 1/8 by 1/8. I'm sure these rivets would fit perfectly, but I settled on 5/32 x 1/8 rivets. I thought these would be meatier. I bought a $12 rivet gun and quickly installed the anchors. This was my first time working with rivets and they were easy to install and very strong. After installing the other two anchors on top of the hood latches, I connected the link straps to the anchors and then adjusted the straps tight. The risers were installed a month ago and give the Wrangler a great look. They also work well off-road in places where small branches and bushes overhang dirt roads. I didn't notice any additional wind noise at highway speeds. It might have something to do with putting the door pillar anchors as high as possible, but I'm not sure! It was an easy setup and I'm not very mechanically inclined. I highly recommend this product.