Review on 🌈 Cooler Master MASTERFAN ARGB/PWM Hub - 6-Port Addressable RGB Lighting with PWM (1-to-6 ARGB PWM Hub) by Jonathan Ulsth

Works great. Fan control is as it should be and aRGB control (I'm using RGB Fusion 2.x, Gigabyte B450 ITX) was perfect. The hub itself is about the size of 3 SSDs stacked on top of each other. aRGB ports found - they are small. If your RGB has extra plastic around the pins you will need to trim it off. I have 3 Enermax Squa RGB fans and 2 Fractal Design Prisma AL14 fans. They all took around 1-2mm of plastic cut off on either side of the RGB connector to fit into the hub. (Look at the picture of the white RGB cable, you can see a piece of black plastic that I had to trim the edges of. The black cable had extra "edges" of plastic on all four sides that I had to trim .) The PWM ports are also tight. These plugs all fit, so I didn't have to modify any of them, but it takes quite a bit of force to pull them back out. This keeps your cables where they should be. Just be sure to hold the connector itself and not the wires if you try to remove them later. The package includes a hub with magnetic mounts on the back (very strong too!), a 6-8 inch PWM cable and a standard aRGB cable (5V, D, _, G) to a 2-pin cable about 6 inches. This cable even has an additional old-style 1-inch Gigabyte aRGB connector that I didn't have to use. My B450 AORUS PRO WIFI connected directly to the standard port. The delivery to me took several weeks (Montana, USA), but I knew that beforehand on the invoice. Overall I'm very happy with it. Since I have an ITX motherboard, I only have 1 aRGB header and 1 Sys_Fan header. This allows me to fill every fan slot in my case and even leave a few RGB connectors that can be used for light strips.