You need a crimping tool or you will have problems. You cannot crimp them by hand. I don't know how to separate them after you fully insert the pin into the connector. With the small flange toward the end of the cable, place the small O-ring on the cable, crimp the terminal pin to the cable and the small O-ring to the terminal, and insert into the connector body. .The instructions state that before inserting the pin, you must remove the red part from the connector housing. It may be necessary, I'm not sure.
Replace Car Bumper Clips: GOOACC 100Pcs For Nissan, Mazda And Infiniti, Including Fastener Remover
33 Review
Off-Road Fender Flares For Jeep Wrangler 2007-2018 JK & JKU Unlimited - Heavy Duty Flat Textured Steel Mud Guards In Black (Set Of 4) By Hikotor For Front And Rear Replacement (2 Or 4 Door Options)
47 Review
Upgrade Your Mazda MX-5 Miata With CravenSpeed'S USA-Made Door Bushings
39 Review
820Pcs Car Push Retainer Clips & Fasteners Assortment - Ford GM Toyota Honda Chrysler BMW Benz Nissan Subaru Audi Mazda
32 Review