Review on 🖥️ Aeon Stands and Mounts 40200: Premium Full Motion TV Wall Mount with 28" Extension (Black) by Kevin Lechtenberg

I have a bedroom that is about 12 square meters and I wanted a bed, chairs, a TV and a little more space. All requirements were thus fully met. The bed is against the wall and the TV is against the same wall a little at the foot of the bed. Leaning against the wall allows you to watch TV from chairs across from the bed, or I can pull it out and rotate it perpendicular to the wall to watch TV in bed (because it's at the foot of my bed). My 55 inch TV from around 2012, when it wasn't as heavy but still not as light as it is now, holds up well even fully extended. Expert Advice. They tend to break. Save yourself the hassle and spend a few bucks on new screws and washers at your local hardware store. Make pilot holes (the holes are slightly smaller than the center of the screw if you pretend to cut the threads). Finally, I usually throw in a washer, then a nut that's too big to use alone as a spacer (big enough for the lag bolt threads to go through), then another washer behind the bracket, just make sure you use it extend. screws for placement. Then when it's time to remove the bracket, it won't stick to the paintwork and won't tear it off. Instead, you'll just have a few dents where the washers should be filled with putty, and then small circles that need painting. Ignore my dirty cords, I just got back from a long out of state project and was in a hurry. to restart the FireTV Stick. ;-)