Review on Create Your Own Buttons With Mophorn Button Maker Machine - Kit Includes 1000+ Parts And Circle Cutter! by Mathew Hishmeh

I make QR codes on buttons (printed with a common printer) I hope to mass cut with a Cricut Maker machine. I dont like cutting individual pieces.The Button maker is sturdy, but i had to Bolt it down with MDF (heavy plywood) as a BASE. And it works great. Also i check the alignment of everything before i use it. And use a silicon type of gel to keep the Mylar / Plastic in place so it does not buckle. I have had a more than 99.9% success rate on these buttons. (User error was mine for not having the right sized printed circular paper in the first slot).The paper needed to be printed and cut needs to be 1.313 round. (Just make sure the plastic can cover the printed cut circles and you will be fine). I use it for N95 Face Mask Holders the buttons are "ear savers" or "face mask holders" the pins keep it in place.• I applied white Lithium Grease (the WD-40 brand) to the base of the sliding unit , and all metal parts (Its white metal on metal grease)• Finally, you dont need to tug hard on this handle. The first PHASE (1) just smothly snaps the image to the button in a single "snug" motion (no need to jerk alot of weight into it). The Second PHASE (2) is sliding the shuttle of the maker to apply the backing. .this is one FIRM pull and it pressures it into the first part of the button. DONT FORCE it - its not gonna break, but not needed to go all "HULK" on the situation. If you want to have a tighter seal or edge. turn the button over on the Second PHASE (2) slot and lightly add some pressure on the upside down button. you may see a slight difference of compression.- WHAT COULD HAVE BEEN BETTER -• Metal Pins instead of the plastic ones (but the plastic ones, yes are very durable)• The circle cutter that comes with it. probably would be better if it was not sold with it, cause it sucks - i threw it out.• Seller could have offered like minded circle cutters or circle punch - to make it more efficient• Seller could have mentioned the diameter or size( 1.313 inches) of circles needed for image & cut areaLastly, Im not a pro at this. but i do know my way around paper and technology.