Header banner
Revain logoHome Page
Aquarium Lanter photo
1 Level
791 Review
37 Karma

Review on Gizmo Dorks Laminated Adhesive for Printers: Boost Your Documents' Durability! by Aquarium Lanter

Revainrating 5 out of 5

Incredible adhesion, smooth underside of the prints!

Media could not be loaded. Works better than anything I've tried before and produces incredible adhesion and smooth glass on every print. Haven't removed it yet so I gave it 3 stars for 'easy to remove'. It probably just takes a little time to slowly peel it off. It is very easy to install if you take your time. Just for reference, I've tried: - Glue sticks (total mess and glue builds up and doesn't work if you want to make accurate prints. - I just use a heated glass bed, which is great when the filament sticks, but large prints warp after a few hours of prints and the bottom of the prints is rough with lines. Bought from them. This decal worked very well although it left a slightly rough surface on the bottom of the prints. Until the glue started to blister over time and I couldn't figure out why my prints were hitting the hot end and being dragged around even though my glass was deformed but when I removed the sticker I could see where the adhesive was still active and where it wasn't.This was mine Favorite option until I got the PEI fittings now I will never use anything else again Professional baby!

Pros
  • Industrial & Scientific
Cons
  • Some minor issues