Review on 🔧 Moldable Plastic – 6oz InstaMorph Formula by Amy Mcleod

Very satisfied! I broke half of my front tooth. It was a porcelain veneer. I did something stupid: I ripped the tape with my teeth. To make matters worse, I can't find the part that broke off, otherwise I'd just glue it back on. Anyway since I'm not rich I did a lot of research online. I decided to try this (and a pack of fake single teeth). Turns out that's all I need. This is by no means a permanent solution, but it works as long as I'm willing to put a small bowl of water in the microwave, heat it for 30 seconds, and then use a small spoon to shape the plastic into a very thin strip. and place the strip on my front teeth and start stretching/shaping the plastic to make it a custom fit. I use a spoon on the edge of the bowl because as soon as you take it out it starts to cool and solidify. So try to shape as much as possible in the water with one tool. It's easier for me to mold it onto two or three existing teeth than trying to mold a single tooth. From there I can use pliers and/or wire cutters to trim off the excess and shape it into a mouth. The good thing is that I can dip it in hot water again to make it flexible again to adjust. I keep it in my mouth and drink something cold to fix it. I can get about 2 or 3 days use for a molding. After that, all coffee and other products will discolor beyond the normal color. I'm also missing an upper molar and I can easily stick plastic on it, press it against the lower tooth. I get it. It's very flexible knowing that if you get confused you just have to start over and wait less than a minute for the water to heat up. Definitely cheaper than $1200 to replace the veneer or $600 to repair. I will fix it, just need time to save some money. I bought this product at the time.